2006 Bombardier Outlander Max Series Factory Service Manual, Page 341Get this manual
Section 08 DRIVETRAIN Subsection 01 (4X4 COUPLING UNIT)
GENERAL
During assemblyinstallation, use the torque values and services products as in the exploded view(s)Clean threads before applying threadlockerRefer to SELF-LOCKING FASTENERS and LOCTITE APPLICATION at the beginning of this manual for complete procedure
If the selector is out of specifications, check wires, connectors and replace the selector if necessaryIf the selector is good, replace the actuator
Removal
NOTE: Before beginning any servicing on the actuator, make sure the vehicle is in 2WD positionRemove the LH and RH footrests Unplug actuator connectorUnscrew actuator bolts no2&
WARNING
Torque wrench tightening specifications must strictly be adhered toLocking devices (e.g locking tabs, elastic stop nuts, self-locking fasteners, etc must be installed or replaced with new ones where specifiedIf the efficiency of locking device is impaired, it must be renewed