2006 Bombardier Outlander Max Series Factory Service Manual, Page 316Get this manual
Section 07 TRANSMISSION Subsection 02 (GEARBOX AND 4X4 COUPLING UNIT)
To remove ball bearings of bevel gear no36 and needle bearing of countershaft no33, use blind hole bearing puller
A6100utiOJA
For countershaft ball bearing, remove screw and intermediate gear shaft, then push with suitable puller from outside in
PRESS SHAFT IN THE DIRECTION AS SHOWN BY THE ARROW 1Intermediate gear shaft 2Left housing
Bearing Removal in Housing If necessary heat housing up to 1aaoc (212F) before removing ball bearings or needle bearings
Clean oil, outside and before heating CAUTION: Always support gearbox housings properly when ball bearings or needle bearings are removedHousing damages may occur if this procedure is not performed correctly