2006 Bombardier Outlander Max Series Factory Service Manual, Page 290Get this manual
Section 07 TRANSMISSION Subsection 01 (CONTINUOUSLY VARIABLE TRANSMISSIOf1 (CVT))
NOTE: Apply Isoflex grease (PN 293 550021) on both sides of friction washer no12
CAUTION: Centrifugal levers no7 must move easily after installationRebuild governor cup with new bearing sleeves, thrust washers no6, rollers and slider shoes
Install conical spring washer with its concave side towards drive pulley then install drive pulley screw
CAUTION: Final position has to be aligned with the contact surface of the slider shoes (no protrusion)
1Drive pu lle screw 2Conical spring washer 3Thrust washer
WARNING
Ilever substitute conical spring washer andor screw with jobber onesAlways use BRP genuine parts for this particular case1Top edge of bearing sleeve 2Mating surface of slider shoes 3Vice
CAUTION: Rollers must move easily after installationInsert slider shoes into governor cup to properly slide in guides