2006 Bombardier Outlander Max Series Factory Service Manual, Page 284Get this manual
Section 07 TRANSMISSION Subsection 01 (CONTINUOUSLY VARIABLE TRANSMISSION (CVT))
Block the drive pulleyTo do this, two procedures can be followedFirst Possible Procedure:Remove spark plugsLock crankshaft at TDe position with crankshaft locking bolt (PIN 529 035 617) Refer to CYLINDER AND HEAD section
7Mark on drive pulley sliding half 2Mark on governor cup
Unscrew the drive pulley screw, then remove it as well as the conical spring washer and thrust washer
7Crankshaft locking bolt 2Engine drive shaft (front side)
Second Possible Procedure: Block drive pulley with the clutch holding tool (PIN 529 006400)