2006 Bombardier Outlander Max Series Factory Service Manual, Page 279Get this manual
Section 07 TRANSMISSION Subsection 01 (CONTINUOUSLY VARIABLE TRANSIVIISSION (CVT))
CLUTCH SPRING SQUARENESS
SERVICE LIMIT
3.8 mm (.150 in)
Assembly
For installation, reverse the removal procedurePay attention to following detailsHeat ball bearing area up to ball bearing installation
aaoc (212F) before
NOTE: Place new ball bearing in freezer for 1a minutes before installationInstall ball bearing with the writing on top and push only on the outer ringR4QOmotr189A
1Retaining ring 2Torque gear
Installation
For installation, reverse the removal procedurePay attention to the following detailsInstall sliding half no30 into fixed half no26Place O-ring no34 on main shaft splines and move it with spacer no35 in end position