2006 Bombardier Outlander Max Series Factory Service Manual, Page 275Get this manual
Section 07 TRANSMISSION Subsection 01 (CONTINUOUSLY VARIABLE TRANSMISSION (CVT))
Check for any marks on fixed half plateReplace if necessaryCheck ring gear teeth for excessive wear or other damage Replace fixed half if necessary
Assembly
For assembly, reverse the disassembly procedurePay attention to following details Apply Isoflex grease (PN 293 550021) on spring sleeves no10 and their springs then between one-way clutch bearings&
WARNING
Fixed half and ring gear are balanced togetherAlways replace both parts together otherwise severe injury andor damages may occu rSpring Measure spring free length and squarenessIf spring no17 is out of specification, replace by newSPRING FREE LENGTH
SERVICE LIMIT
CAUTION: Centrifugal lever and rollers must
move easily after installationInsert slider shoes no9 into governor cup to properly slide in guides
Installation
For installation, reverse the removal procedurePay attention to the following details
WARNING
75 mm (2953 in)