2006 Bombardier Outlander Max Series Factory Service Manual, Page 269Get this manual
Section 07 TRANSMISSION Subsection 01 (CONTINUOUSLY VARIABLE TRANSMISSION (CVT))
R400motrl58A
1Drive belt
A Belt width
R400molr156A
1Driven pulley expander 2Fixed half of driven pulley
Installation
For installation, reverse the removal procedure Pay attention to following detailsThe maximum drive belt life span is obtained when the drive belt has the proper rotation directionInstall it so that the arrow prin ted on belt is pointing towards the ba ck of the vehicle
To remove belt no4, slip the belt over the top edge of sliding half, as shown
NOTE: Put small amount of Locti te 5910 (PIN 293 800 081) in the groove of CVT cover to ease installation of CVT cover with gasket no3 Install the center top screw of cover in firstInstall the other screws then torque them in crisscross sequence