2006 Bombardier Outlander Max Series Factory Service Manual, Page 238Get this manual
Section 06 ELECTRICAL SYSTEM Subsection 03 (STARTING SYSTEM)
Installation
Installation is the reverse of removal procedure However, pay particular attention to the followingMake sure that starter and engine mating surfaces are free of debrisSerious problem may arise if the starter is not properly alignedBring starter close to its locationRotate it so that its mounting ear allows installation in engine housing Push in place and align mounting ear to install screwTorque starter screw to 25 N-m (18 Ibf-ft) Connect the RED (+) cable to the starter and torque nut to N-m (53 Ibf-in)Apply dielectric grease (PIN 293 550 004) on terminal and nutFirst connect RED (+) cable to battery then connect the BLACK (-) cable&