2006 Bombardier Outlander Max Series Factory Service Manual, Page 230Get this manual
Section 06 ELECTRICAL SYSTEM Subsection 03 (STARTING SYSTEM)
Ensure the solenoid receives electric current as follows Using multimeter, measure the voltage between the YELLOWRED and WHITERED wires when pressing the start button with the ignition key turned ONNOTE: Disconnect wires from solenoid If solenoid does not properly receive current, the electronic module can be suspectedSee ELECTRONIC MODULE section belowIf solenoid receives currenttest the solenoid as follows Disconnect large cables from solenoidInspect connections and clean as necessarySolenoid condition can be checked with an ohmmeterInstall test probes on large connectors of solenoidMeasure resistance when current is applied to small connectors; if it is more than few ohms, replace solenoidIf solenoid test good, check the electric starterIf starter test good, the electronic module can be suspected See ELECTRONIC MODULE below
PART REPLACEMENT ELECTRIC STARTER
Removal
Turn OFF ignition switchDisconnect BLACK (-) cable from battery&
WARNING