2006 Bombardier Outlander Max Series Factory Service Manual, Page 222Get this manual
Section 06 ELECTRICAL SYSTEM Subsection 02 (IGNITION SYSTEM)
OUTLANDER 800 SERIES GENERAL
The EMS controls the ignition system For more informationrefer to ENGINE MANAGEMENTThe ECM (Engine Control Module) energizes the primary side of ignition coil individually while the ECM completes the circuit for each cylinder by switching it to the ground at the right momentThe ECM can detect open and short circuit in the primary winding but it does not check the secondary winding&
WARNING
Using multimeter, test switch as follows
l'Jever check for engine ignition spark from an open coil andor spark plug as spark may cause potential fuel vapor to igniteFor best electrical measurement results, use the multimeter Fluke 111 (PN 529035 868)
529035868
IGNITION SWITCH POSITION
RESISTANCE