2006 Bombardier Outlander Max Series Factory Service Manual, Page 217Get this manual
Section 06 ELECTRICAL SYSTEM Subsection 02 (IGNITION SYSTEM)
PROCEDURES
Safety Precautions
Use multimeter and measure the resistance between the following wires POSITION OFF OFF ON (wilights) ON (wlights) WIRE RED and REDYELLOW RED and REDNIOLET RED and REDYELLOW RED and REDNIOLET RED and REDYELLOW RED and REDNIOLET RESISTANCE Infinite (O.l) Infinite (O.l)
0.2 0.2 S1 max0.2 0.2 S1 ma x&
WARNING
To prevent powerful electric shocks while cranking engine, neither touch any electronic ignition components (ignition coil, wire harness, etc nor tester lead clipsAlso make sure that tester leads do not touch any metallic object
MAIN FUSE CONDITION
Check main fuse (20 A) condition Replace burnt fuse as necessary
ON (wo lights) ON (wio lights)
Infinite (O .l)
0.2 0.2 S1 max
CAUTION: Do not use higher rated fuse as this can cause severe damage
Replace switch if defective