2006 Bombardier Outlander Max Series Factory Service Manual, Page 203Get this manual
Section 05 FUEL SYSTEM Subsection 02 (CARBURETOR)
Slide rubber protector to expose throttle cable adjusterRemove carburetor side cover
Installation
For installation, reverse the removal procedure
Adjustment
WARNING
Ensure the key is turned OFF, prior to perform the throttle cable adjustmentSlide rubber protector back to expose throttle cable adjusterLoosen lock nut then turn the adjuster to obtain correct throttle lever free playNOTE: Measure throttle free play at the tip of throttle leverTighten lock nut and reinstall protectorWith the transmission lever on PARK position, start engineCheck if the throttle cable is adjusted correctly by turning handlebar fully right then fully leftIf the engine RPM increase, readjust the throttle lever free playTurn engine off and unscrew stopper screw located under throttle lever housingPress throttle lever at wide open throttle position and turn screw until it touches the throttle leverTurn the stopper screw 12 turn again and lock it with the lock nut