2006 Bombardier Outlander Max Series Factory Service Manual, Page 198Get this manual
Section 05 FUEL SYSTEM Subsection 02 (CARBURETOR)
GENERAL
Before performing any job on the fuel system, always turn fuel valve to OFF position and disconnect BLACK (-) cable from battery
NOTE: Take care not to drop the choke plungerIf so, check plunger for damages and replace if necessaryOn the RH side of vehicle, remove the throttle cable from carburetorSee THROTTLE CABLE further in this section Unscrew clamp retaining carburetor to the intake adaptorPullout carburetor&
WARNING
Always disconnect battery exactly in the specified order, BLACK (-) cable firstIt is recommended to disconnect electrical connections prior to disconnecting fuel lines
Cleaning and Inspection
PROCEDURES
The entire carburetor should be cleaned with general solvent and dried with compressed air before disassembly
CARBURETOR
Although some jets can be replaced by other jets from other carburetors, such modifications should not be performedThey can greatly affect engine calibration and can cause severe damage to engineUse only recommended jetting specific for this carburetor