2006 Bombardier Outlander Max Series Factory Service Manual, Page 167Get this manual
Section 04 ENGINE MANAGEMENT (V-810) Subsection 03 (COMPOIIENT INSPECTION, REPLACEMENT AND ADJUSTMENT)
If resistance test of valve windings is good, check continuity of circuits A-35, A-36, A-37, A-38If not good, checkrepair wiringconnectors
Visual Inspection
NOTE: Make sure the ignition key is turned off during the following procedureRemove idle bypass valve from throttle body, Check the piston and bypass channel for dirtdeposits which can cause sticking piston
CAUTION: Always keep the ignition key turned OFF, while the idle bypass valve is removedCAUTION: Do not try to operate the piston of the idle bypass valve when it is dismountedAlso do not move the piston by handThe drive screw is very sensitive and may be destroyedUsing part cleaner, clean idle bypass in throttle body from contamination then use an air gun to dry it