2006 Bombardier Outlander Max Series Factory Service Manual, Page 166Get this manual
Section 04 ENGINE MANAGEMENT (V-810) Subsection 03 (COMPONENT INSPECTION, REPLACEMENT AND ADJUSTMENT)
Install the new TPS Apply Loctite 243 (PIN 293 800 060) on the TPS retaining screws, then torque to N-m (27lbf-in)Reinstall remaining removed partsProceed with the CLOSED THROTTLE AND IDLE ACTUATOR RESETSee below
Open throttle approximately one quarter then quickly releaseRepeattimes to settle throttle plateIf stopper does not rest against its stop lever, perform throttle cable adjustmentRefer to THROTTLE BODY in this sectionTo reset valve and TPS, click on the Reset button in the Setting section of B.U.D.S Setting losed Throttle and Idle Throttle Opening:
Closed Throttle and Idle Actuator Reset
NOTE: This operation performs reset of the values in the ECMThis reset is very ImportantThe setting of the TPS will determine the basic parameters for all fuel mapping and several ECM calculations and the setting of the idle bypass valve will determine the basic parameters for the idle speed control of the engineNOTE: Reset must be done each time the throttle position sensor (TPS) is loosened or removed or throttle body is replaced or ECM is replacedCAUTION: An improperly set TPS or idle bypass valve may lead to poor engine performance and emission compliance could possibly be affected In addition, improper idle bypass valve reset may lead to poor engine starting, improper idle (too low or too high) and engine stop on decelerationUse the Vehicle Communication Kit (VCK) with the B.UD.S software to perform this adjustmentRemove throttle body cap and ensure the throttle cam of throttle body rests against set screw without any tension in the cable