2006 Bombardier Outlander Max Series Factory Service Manual, Page 144Get this manual
Section 04 ENGINE MANAGEMENT (V-810) Subsection 02 (DIAGNOSTIC PROCEDURE)
DESCRIPTION
ENGINE REACTION
Limp home
DESCRIPTION OF LIMP HOME EFFECT
No rev but cylinder will not work properly
No ignition output stage cylinder #1
Blown fuse, damaged circuit wires, damaged connector or damaged igni tion coil
Check fuse F3 Check for 2.2 03 ohm between ignition coil pin sCheck connector HIC connecting the two harnesses togetherCheck system circuit 2-A-1Check fuse F1 Check for 22 03 ohm between ignition coil pins Check connector HIC connecting the two harnesses togetherCheck system circuit 2-A-1Check fuse F4Check for approximately 12 volts between 3-PF-1 and engine ground Check system circuit 2-B-3Check fu se F4Check for disconnected re lay or pin 3-PF-1 and 3-PF-1 Check for approximately 12 volts between 3-PF-1 and engine groundCheck system circuit 2-B-3Check for approximately 50 ohms between pins and and also between pins Band of the idle air control valve Check for damaged circuit wires Check system circuits 2-A-35, 2-A-36, 2-A-37 and 2-A-38Check for damaged connector or damaged ECM output pinsCheck for approximately 50 ohms between pins and and also between pins Band of the idle air control valveCheck for damaged circuit wiresCheck system circuits 2-A-35, 2-A-36, 2-A-37 and 2-A-38 Check for damaged connector or damaged ECM output pinsClean OESS keyProgram the OESS key