2006 Bombardier Outlander Max Series Factory Service Manual, Page 141Get this manual
Section 04 ENGINE MANAGEMENT (V-810) Subsection 02 (DIAGNOSTIC PROCEDURE)
FAULT CODE TABLE
P-CODE DESCRI PTI ON CAUSE ACTION GAUGE ENGINE REACTION Limp home DESCRIPTION OF LIMP HOME EFFECT No rev limit but air pressure is set to default value
Air pressure sensor voltage out of range
Sensing port dirty or blockedSensor failure or unexpected reading at idleSensor fallen out of intake manifold
Make sure sensor's connector is fully insertedCheck for approximately volts between sensor connector pins and Check system circu its 2-A-12, 2-A-28 and 2-A-40 Make sure sensor's connector is fully insertedCheck for approximately volts between sensor connector pins and 3Check system circuits 2-A-12, 2-A-28 and 2-A-40 Make sure sensor's connector is fully inserted Check for approximately volts between sensor connector pins and 3Check system circuits 2-A-12, 2-A-28 and 2-A-40Check system circuits 2-A-7 and 2-A-2lReplace the sensor if necessary
Engine pilot lampcheck engine and limp home
Ai pressure sensor voltage too low