2006 Bombardier Outlander Max Series Factory Service Manual, Page 139Get this manual
Section 04 ENGINE MANAGEMENT (V-810) Subsection 02 (DIAGNOSTIC PROCEDURE)
Number means that only one" ECU" is connected (either ECM or multi-function speedometer) Therefore, there is problemCheck fuses and connections
To diagnose this fully, it is recommended to operate the throttle through its full rangeIt is also recommended to release the throttle quickly as this may also reveal fault that is intermittentPOSSIBLE CAUSES ACTION Fi xTighten and reset Closed Throttle and Idle Actuator Repla ce and reset Closed Throttle and Id Ie ActuatorRepairIf bad wiring, repairIf bad TPS, replace and reset Closed Throttle and Idle ActuatorRepla ce and reset Closed Throttle and Idle Actuator
F16HOWA
Check if connector is disconnected from TPS Check if sensor is loose
ONLY ONE "Eeu" IS WORKINGTHERE IS PROBLEM