2006 Bombardier Outlander Max Series Factory Service Manual, Page 136Get this manual
Section 04 ENGINE MANAGEMENT (V-810) Subsection 02 (DIAGNOSTIC PROCEDURE)
END will appear when all fault codes have been displayedNOTE: If no button is depressed, the fault codes will automatically scroll down (if more than one) until END is reachedTo exit on-board diagnostic mode, press selector button and HOLD seconds
VCK (Vehicle Communication Kit)
The VCK (Vehicle Communication Kit) (PIN 529 035 981)
1Press and hold seconds to exit
NOTEIf the on-board diagnostic mode is not exited, it will remain in function even if ignition key is turned off
- 529 035 677: Multi Protocol Interface (MPI) with four AA-l.5 VDC alkaline batteries529 035 807 Diagnostic cable529 035 679 6-pin adapter529 035 697: DB9 female to DB9 male serial cable
PROCEDURES COIVIIVIUNICATION TOOLS
Two tools can be used to communicate with the memory of the ECM
SOFTWARE
Ensure to use the latest B.U.D.S version 2.3.2 or above available on BOSSWebB.U.D.S (Bombardier Utility and Diagno stic Software) is designed to allow actuators, sensors and electronic equipments inspection, diagnostic options and reset such as the clos ed throttle and idle actuatorFor more information pertaining to the use of the B.U .D.Ssoftware, use its help which contains detailed information on its functions