2006 Bombardier Outlander Max Series Factory Service Manual, Page 65Get this manual
Section 02 TROUBLESHOOTING Subsection 02 (TROUBLESHOOTING CHART)
SYMPTOM COIJDITION TestInspection
ENGINE DOES NOT START -
NO SPARK AT SPARK PLUG
AT ENGIIJE CRAIJKIIJG1Verify spark plug conditionaDefective, improperly set, worn out, fouledIdentify source of problem and correctReplace spark plug2Check ignition coil (refer to IGNITION SYSTEM)aDefective partReplace ignition coil3Check crankshaft position sensor (refer to COMPONENT INSPECTION AND ADJUSTMENT) aDefective crankshaft position sensorCorroded connector terminalsReplace crankshaft position sensorClean terminals and apply silicone dielectric grease4Check condition of wiring harness and connectorsaCables andor connectors are damaged andor corrodedReplace connectors or complete wiring harness (refer to COMPONENT INSPECTION AND ADJUSTMENT) Clean terminals and apply silicone dielectric grease5Check fault codes in B.UD.Ssystem aCheck if electrical actuator(s) isare defectiveReplace defective part(s) (refer to COMPONENT INSPECTION AND ADJUSTMENT)