2006 Bombardier Outlander Max Series Factory Service Manual, Page 44Get this manual
Section 02 TROUBLESHOOTING Subsection 01 (TROUBLESHOOTING CHART)
SYMPTOM CONDITION TestInspection
DRIVE PULLEY NOISE WHEN ACCELERATINGDECELERATINGNORMAL USE1 Check items to of drive pulley noise in idle speed2Check if belt runs in dry conditionsaDrive pulley area is wetcontaminated due to waterdirt intrusionClean driven pulley area andor drain water out of CVT cover
3Check drivedriven pulley screw for torqueaLoose screw on drive andor driven pulleyRetighten screw with recommended torque
4Check cam and driven pulley fixed half for wearaCam andor drive pulley fixed half out of wear limit andor damagedReplace damaged part(s)5Check torque gear fixed in driven pulley sliding half for wearaTorque gear out of wear limit andor damagedReplace torque gear (refer to CV7)6Check for foreign particles in CVT area (stones, dirtetcaSmall particles damaged belt andor pulley surface(s)Clean system and replace damaged parts (refer to CV7)
SYMPTOM CONDITION TestInspection