2005-2007 Bombardier Rally 200 Factory Service Manual, Page 276Get this manual
Section 09 BODYFRAME Subsection 02 (FRAME)
Remove the bolt no16 at the other end of support after removing the footwell
Installation
Installation is the reverse of removal procedure
Cleaning
Clean frame no11 with appropriate cleaners and rinse thoroughlyNOTE: Clean the draining holes under frameThe drain holes are located at the rear of bottom side of frameTouch up all metal spots where paint has been scratched offSpray all bare metal parts of vehicle with metal protectorV06L1DA
Welding
Steel Frame: electric welding amperage: 70110 voltage: 2024 rod: E-7014 (332 in)CAUTION: Before performing electrical welding anywhere on the vehicle, unplug the electronic module connectorAlso unplug the BLACK (-) cable from the battery and the voltage regulatorThis will protect the electronic module and battery against damage caused by flowing current when weldingNOTE: Install the ground as close as possible from the reparation areaCAUTION: If welding is to be done near plastic material, it is recommended to remove the part from the area or to protect it with aluminum foil to prevent damage