2005-2007 Bombardier Rally 200 Factory Service Manual, Page 218Get this manual
Section 05 DRIVE TRAIN Subsection 01 (FRONT DRIVE)
Removal
Inner Bearing Remove and discard wear ringOffset inner sleeve no8Using hammer and punch, eject defective bearingNOTE: Be careful not to damage hub, studs or brake disk while removing defective bearing3
V06H0PA
1Wear ring 2Synthetic grease
Install wheel hub no6Put the bushing in placePut the wheel hub nut and tightenInstall new cotter pinBoth ends of cotter pin must be foldedInstall front wheelPut vehicle back on the ground
1Wear ring 2Ball bearing 3Inner sleeve
WEAR RING
Removal
Remove wheel hubUsing screwdriver, remove wear ring no5
Outer Bearing Offset inner sleeve no8Using hammer and punch, eject defective bearingNOTE: Be careful not to damage hub, studs or brake disk while removing defective bearing3