2005-2007 Bombardier Rally 200 Factory Service Manual, Page 169Get this manual
Section 03 FUEL SYSTEM Subsection 02 (CARBURETOR)
CARBURETOR FLOAT LEVEL ADJUSTMENT FLOAT LEVEL 15 mm mm (.591 in .039 in)
Installation
To install carburetor on engine, inverse removal procedure, as described: Carefully replace carburetor cap no2 in its original positionMake sure valve piston no5 groove passes the inside protrusion in carburetor no3 before closing the carburetor cap no2
WARNING
V06F0HA
TYPICAL 1Gauge tips 2"L" arm AHeight
Throttle valve piston groove must be aligned with carburetor inside protrusion to allow throttle valve piston to reach idle bottom positionOtherwise, throttle valve piston will be half opened leading to potentially dangerous situation
V06F0XA