2005-2007 Bombardier Rally 200 Factory Service Manual, Page 152Get this manual
Section 02 ENGINE Subsection 10 (CONSTANT VELOCITY TRANSMISSION (CVT))
Check if the gasket is brittle, hard or otherwise damagedReplace if necessaryCheck if the CVT cover bearing no8 must turn smoothly and freelyOtherwise, replace itSee CVT COVER BEARING below)
529 035 617
Installation
Place the gasket in the CVT cover grooveInstall the CVT coverAlign the end of driven pulley nut no9 with the ball bearing no8NOTE: Do not overdo the CVT cover to install itInstall the center top screw of cover in firstInstall the other screws then torque them in crisscross sequenceInstall hoses then torque clamps
CVT COVER BEARING
Inspection
Check if the CVT cover bearing no8 must turn smoothly and freelyOtherwise, replace itR175motr34A
Removal
Heat up CVT cover to about 100C (212F) for an easy bearing removalCAUTION: Do not overheatUsing slide hammer with the proper attachment, remove the bearing