2005-2007 Bombardier Rally 200 Factory Service Manual, Page 129Get this manual

Section 02 ENGINE Subsection 08 (CRANKSHAFT)
NOTE: Always degrease taper on crankshaft MAG before reinstalling rotor
CRANKCASE
Disassembly
Remove: engine from vehicle (refer to REMOVAL AND INSTALLATION) magneto housing cover and rotor (refer to MAGNETO SYSTEM) cylinder head and cylinder (refer to CYLINDER AND HEAD) timing chain drive pulley (refer to CVT, see DRIVE PULLEY) driven pulley (if necessary) gearbox components (if necessary) screws retaining crankcase MAG
R175motr14A

1Shim for MAG side 2Oil pump gear 3Timing chain gear

Install the crankshaft locking bolt (PN 529 035 617)CAUTION: Install crankshaft locking bolt right away to put crankshaft in TDC position before installing rockers (refer to CYLINDER AND HEAD)Install new gasket no15Hand-torqued crankcase screws as per following sequenceRepeat procedure, retightening all screws to 10 Nm (89 lbfin)4 11 2

• ATV
• Jet Ski
• Outboard Motors
• Personal Watercraft
• Snowmobiles
• Stern Drives