2005-2007 Bombardier Rally 200 Factory Service Manual, Page 90Get this manual
Section 02 ENGINE Subsection 06 (LUBRICATION SYSTEM)
Stop engineWait while to allow oil to flow down to crankcase then check oil levelRefill as necessaryDispose oil as per your local environmental regulations
Installation
For installation, reverse the removal procedureRefill engine at the proper level with the recommended oilRefer to TECHNICAL DATA for capacityReinstall oil dipstick Start engine and let idle for few minutesEnsure plug screw and magnetic drain plug areas are not leakingStop engineWait minimum of minutes to allow oil to flow down to crankcase then check oil levelRefill as necessaryOil level should be within operating range, with dipstick screwed in completely
OIL STRAINER
Removal
Remove: engine oil (refer to OIL CHANGE) screw no10 retaining oil strainer no8CAUTION: Pay attention not to lose gasket ring no9 on plug screw1 3
ENGINE OIL PRESSURE REGULATOR
The oil pressure regulator system works when the oil pressure exceeds 400 kPa (58 PSI)If oil pressure is low, check ball of oil pressure regulator valve for contamination (refer to TROUBLESHOOTING)