2005-2007 Bombardier Rally 200 Factory Service Manual, Page 79Get this manual
Section 02 ENGINE Subsection 05 (MAGNETO SYSTEM)
Inspection
Check magneto cover for cracks or other damagesReplace if necessary
Installation
Remove all residues on mating surfacesThe mating surfaces must be cleaned of any contaminationsNOTE: Clean all metal component in non-ferrous metal cleanerUse Bombardier gasket remover (PN 413 708 500) or suitable equivalent4 1
WARNING
Wear safety glasses and work in well ventilated area when working with strong chemical productsAlso wear suitable non-absorbent gloves to protect your handsFor installation, reverse the removal procedureHowever, pay attention to the followingIMPORTANT: Apply small amount of clear silicone sealant (PN 293 800 086) on mating surface in grommet area before placing the gasket1