2005-2007 Bombardier Rally 200 Factory Service Manual, Page 67Get this manual
Section 02 ENGINE Subsection 04 (COOLING SYSTEM)
Installation
For installation, reverse the removal procedure, pay attention to the following detailsInstall new gasket no14Place bleeding screw then torque to Nm (35 lbfin)1 2
WATER TEMPERATURE SWITCH
Removal
NOTE: The temperature switch no16 is located on the top of cylinder head, near the thermostat housingRemove: wire from temperature switch water temperature switch
R175motr166B
1Gasket 2Bleeding screw
V06C3YA
Install the thermostat cover then torque screws to Nm (44 lbfin)NOTE: Do not forget to place washers no151 2