2005-2007 Bombardier Rally 200 Factory Service Manual, Page 59Get this manual
Section 02 ENGINE Subsection 03 (REMOVAL AND INSTALLATION)
CAUTION: Do not use screwdriver when removing anti-vibration bushing
Installation
Insert the anti-vibration bushings in engine support, one on each sideDo not forget to place the sleeve no12 between bushings
EXHAUST PIPE
WARNING
Never touch exhaust system components immediately after the engine has been run because these components are very hot
Using new muffler gasket no17, install the exhaust pipe into mufflerNOTE: Do not forget the exhaust pipe clamp no13On cylinder head side, install new gasket no16 on the exhaust pipe end then tighten the exhaust pipe on cylinder headTighten exhaust pipe clamp
MUFFLER
Removal
Remove cotter pin no18 and washer no19Unscrew the clamp no13Remove muffler no142 3