2005-2007 Bombardier Rally 200 Factory Service Manual, Page 45Get this manual
Section 02 ENGINE Subsection 02 (LEAK TEST)
LEAK TEST
SERVICE TOOLS
Description Part Number Page
crankshaft locking bolt 529 035 617 28 leak tester529 035 661 28
VERIFICATION
Before performing the cylinder leak test, verify the following: intake portair filter contaminated (clogged) with dirt, sand, etc(leads to worn valves, piston rings and finally to leak of power) CAUTION: In case of piston ring andor valve replacement always clean the whole engine and replace oil and oil filter blue exhaust gas means damagedworn piston rings clamp(s) tightness radiator and hoses oily contamination on leak indicator hole (near oil pressure switch) means damaged oil seal on water pump shaft coolant out of leak indicator hole means damaged oil seal on water pump shaft (refer to COOLING SYSTEM)NOTE: For all the checkpoints mentioned above see the appropriate engine section to diagnose and repair the engine