2005-2007 Bombardier Rally 200 Factory Service Manual, Page 28Get this manual
Section 01 MAINTENANCE Subsection 02 (MAINTENANCE)
Select well-ventilated area and make sure the muffler is cool
WARNING
R175motr131A
1Inlet bore from oil pump to oil filter 2Outlet bore to engine oil providing system 3Oil line to pressure regulator valve
Never run engine in an enclosed area Never perform this operation immediately after the engine has been run because exhaust system is very hot Make sure that there are no combustible materials in the area Wear eye protector and gloves Never stand behind the vehicle while purging exhaust system Respect all applicable laws and regulationsPlace transmission on NEUTRAL position and apply parking brakeRemove the screw retaining the spark arrester to mufflerPull the spark arrester out of muffler
Install filter cover and torque screws to 10 Nm (89 lbfin)Wipe out any oil spillage on engineInspect gasket ring on drain plug and replace as necessaryClean gasket area on engine as well as the drain plug then reinstall plugRefill engine at the proper level with the recommended oilRefer to TECHNICAL DATA for capacityDo not overfillStart engine and let idle for few minutesEnsure oil filter area and drain plug areas are not leakingStop engineWait while to allow oil to flow down to crankcase then check oil levelRefill as necessaryDispose oil as per your local environmental regulations