2004 Bombardier Rally 200 Series Shop Manual, Page 231Get this manual
Section 06 DRIVE TRAIN Subsection 03 (REAR AXLE)
Installation
For installation, reverse the removal procedurePay attention to the following detailsApply synthetic grease (PN 293 550 019) on splinesInstall wheel hub no11Put the O-ring in placePut on the wheel hub nut no8 and tightenRelease rear brakeInstall new cotter pinBoth ends of cotter pin must be foldedInstall rubber capInstall rear wheelPut vehicle back on the groundWith no driver on vehicle, adjust chain tensionTighten the chain tensioner lock bolts
V06H0AA
1Locking nuts
REAR SPROCKET AND HUB
Removal
Lift rear of vehicle and install jack stands under the frame to support the rear of vehicle off the groundRemove RH rear wheel and wheel hub no11Remove drive chain no1