2004 Bombardier Rally 200 Series Shop Manual, Page 229Get this manual
Section 06 DRIVE TRAIN Subsection 03 (REAR AXLE)
GENERAL
During assemblyinstallation, use torque values and service products as in the exploded viewClean threads before applying threadlocker.Refer to SELF-LOCKING FASTENERS and LOCTITE APPLICATION at the beginning of this manual for complete procedure
Lubrication and Cleaning
CAUTION: Never wash the chain with high pressure washer or gasolineDamage to the O-ring will result, causing premature wear and drive chain failureClean the side surfaces of the chain with dry clothNOTE: Do not brush chainLubricate only with an approved O-ring chain lubricantOther commercial chain lubricants may contain solvent which could damage the O-rings
WARNING
Torque wrench tightening specifications must strictly be adhered toLocking devices (ex locking tabs, elastic stop nuts, self-locking fasteners, cotter pin, etc must be installed or replaced with new ones where specifiedIf the efficiency of locking device is impaired, it must be renewedCAUTION: During installation, make sure every part is free from old grease and dirtThis allows for clean re-assembly and will avoid premature wear caused by dirt contaminationAfter each job, ride the vehicle for few minutes and make sure the job is successful; i.eaxle is not loose, chain is not rubbing on any part or making noise, rear brake operates correctly, etc