2004 Bombardier Rally 200 Series Shop Manual, Page 171Get this manual
Section 03 ENGINE Subsection 11 (CVT)
Installation
Place the gasket in the CVT cover grooveInstall the CVT coverAlign the end of driven pulley nut no15 with the ball bearing no4NOTE: Do not overdo the CVT cover to install itInstall the center top screw of cover in firstInstall the other screws then torque them in crisscross sequenceInstall hoses then torque clamps
DRIVE PULLEY
CVT COVER BEARING
Inspection
Check if the CVT cover bearing must turn smoothly and freelyOtherwise, replace itR175motr34A
Removal
Heat up CVT cover to about 100C (212F) for an easy bearing removalCAUTION: Do not overheatUsing slide hammer with the proper attachment, remove the bearing