2004 Bombardier Rally 200 Series Shop Manual, Page 159Get this manual
Section 03 ENGINE Subsection 10 (GEARBOX)
Bearing Removal Procedure Always heat crankcase housing up to 100C (212F) before removing ball bearings andor needle bearing
Install needle bearing no15 with the needle bearing installer (PN 529 035 762) and insertion jig handle (PN 420 877 650)3 1
WARNING
Clean oil, outside and inside, from housing before heatCAUTION: Always support crankcase housings properly when ball bearings or needle bearings are removedCrankcase housing damages may occur if this procedure is not performed correctlyTo remove ball bearings no13 and no17 as well as needle bearing no15, use blind hole bearing pullerR175motr116A
1Intermediate shaft needle bearing 2Needle bearing installer 3Insertion jig handle
R610outi03A