2004 Bombardier Rally 200 Series Shop Manual, Page 152Get this manual
Section 03 ENGINE Subsection 09 (CRANKSHAFT)
Measure plain bearing inside diameterReplace if the measurement is out of specificationA 3
Bearing Removal Procedure
Always heat crankcase housing up to 100C (212F) before removing ball bearings, needle bearings or plain bearings
WARNING
Clean oil, outside and inside, from housing before heatCAUTION: Always support crankcase housings properly when ball bearings, needle bearings or plain bearings are removedCrankcase housing damages may occur if this procedure is not performed correctlyNOTE: Always use press for removal or installation of plain bearing halvesPlain Bearing Procedure Remove plain bearings no10, no11, no12 and no13 with the plain bearing removerinstaller (PN 529 035 855)
R175motr20A
MAG plain bearing with groove Oil bore Split of the plain bearing halves Cylinder base direction Plain bearing inside diameter to be measured in area of oil bore