2004 Bombardier Rally 200 Series Shop Manual, Page 114Get this manual
Section 03 ENGINE Subsection 07 (LUBRICATION SYSTEM)
OIL STRAINER
Removal
Remove: engine oil (refer to OIL CHANGE) screw no10 retaining oil strainer no8CAUTION: Pay attention not to lose gasket ring no9 on plug screw1 3
Start engine and let idle for few minutesEnsure plug screw and magnetic drain plug areas are not leakingStop engineWait minimum of minutes to allow oil to flow down to crankcase then check oil levelRefill as necessaryOil level should be within operating range, with dipstick screwed in completely
ENGINE OIL PRESSURE REGULATOR
The oil pressure regulator is located on the engine PTO side underneath the water inlet port
R175motr133A
1Oil strainer 2Gasket ring 3Plug screw
V06C1VA
1Oil presuure regulator valve plug