2004 Bombardier Quest/Traxter Series Shop Manual, Page 487Get this manual
Section 11 BODYFRAME Subsection 03 (FRAME)
Welding
Steel Frame: electric welding amperage: 70110 voltage: 2024 rod: E-7014 (332 in)CAUTION: Before performing electrical welding anywhere on the vehicle, first disconnect the battery negative cable, then unplug the electronic module connector and the voltage regulatorThis will protect the electronic module and battery against damage caused by flowing current when weldingNOTE: Install the ground as close as possible from the reparation areaCAUTION: If welding is to be done near plastic material, it is recommended to either remove the part from the area or to protect it with aluminum foil to prevent damage