2004 Bombardier Quest/Traxter Series Shop Manual, Page 404Get this manual
Section 08 STEERING SYSTEM Subsection 02 (STEERING SYSTEM)
GENERAL
During assemblyinstallation, use torque values and service products as in the exploded viewClean threads before applying threadlockerRefer to SELF-LOCKING FASTENERS and LOCTITE APPLICATION at the beginning of this manual for complete procedure
WARNING
Torque wrench tightening specifications must strictly be adhered toLocking devices (ex locking tabs, elastic stop nuts, self-locking fasteners, cotter pin, etc must be installed or replaced with new ones where specifiedIf the efficiency of locking device is impaired, it must be renewed
brake handle no2 and master cylinder (see below in this subsection) throttle handle housing no3 and multi-function switch no4 (see below in this subsection) steering clamp mounting bolts no5 and steering clamp no6 handlebar no7NOTE: On applicable models, remove the hand protector and windshieldRefer to BODY
Inspection
Inspect the handlebar for damage, cracks or bending, replace if any problems is detected
Installation