2004 Bombardier Quest/Traxter Series Shop Manual, Page 380Get this manual
Section 07 DRIVE TRAIN Subsection 02 (FRONT DRIVE)
Installation
Apply grease (PN 293 550 019) to the splines and insert the end of drive shaft in differential and pull joint little to make sure that the stop ring is locked in differential side gear groove
V01H0FA
V01H0XA
1Stop ring
Insert the other end of drive shaft in the knuckle and install the knuckle, with hub and brake disk, to the lower and upper suspension armsTorque the castellated nut to 47 Nm (35 lbfft) and install new cotter pinReinstall tie-rodInstall hardened washer on each side of the knuckle armTorque tie-rod castellated nut to 73 Nm (54 lbfft) then install new cotter pinInstall the O-ring, the flat washer and torque the castellated nut on the drive shaft end to 135155 Nm (100114 lbfft)Install new cotter pin and the wheel capReinstall the front wheel(s) and torque nuts to 75 Nm (55 lbfft)