2004 Bombardier Quest/Traxter Series Shop Manual, Page 368Get this manual
Section 06 ELECTRICAL Subsection 07 (HYDRAULICELECTRIC SHIFT SYSTEM)
Resetting the Diagnostic Components Registry
Before resetting the diagnostic components registry, the MPEM needs to be in diagnosticcalibration modeThe registry resets automatically when the following sequence is performed: The jumper on the diagnostic connector is removed while the STARTSTOP button is activatedThe MPEM will reset the registry (see table ABNORMALITY-DIAGNOSIS COMPONENTS and table ABNORMALITY CONDITIONS) and after it will turn off itselfSummary of all Tasks
TASK 1INDICATOR LIGHTS TEST 2CLUTCH MODULATOR CALIBRATION 3SENSORS AND SOLENOIDS TEST 4GBPS CALIBRATION 5STPS CALIBRATION 6TPS CALIBRATION LED "5" blinks first, through "1" and after "Check Engine" through "Neutral" "Check Engine" blinks "Reverse" is ON "Hi-Lo Beam" blinks "1" and "Hi-Lo Beam" are ON OPERATION This validates all indicator lights are good