2004 Bombardier Quest/Traxter Series Shop Manual, Page 361Get this manual
Section 06 ELECTRICAL Subsection 07 (HYDRAULICELECTRIC SHIFT SYSTEM)
Once the MPEM detects the diagnostic jumper in diagnostic connector, it sets itself into the diagnostic calibration modeDuring the diagnosticcalibration mode, the engine is off, all the solenoids are not working, and the accessory output is offNOTE: At any time, if the jumper is removed during the diagnosticcalibration mode, the MPEM is powered off automatically
TESTING
The following tasks are performed in this order by the MPEM in the diagnosticcalibration mode: Task 1: Indicator lights test Task 2: Clutch modulator calibration Task 3: Sensors and solenoids verification Task 4: GBPS (Gear Box Position Sensor) calibration Task 5: STPS (Sub-Transmission Position Sensor) calibration Task 6: TPS (Throttle Position Sensor) calibration (model with AUTOSHIFT mode only)See below for detailed stepsOnce each task has been completed, the MPEM goes to the next task if the proper button(s) is(are) not activated after secondsV01A2VA