2004 Bombardier Quest/Traxter Series Shop Manual, Page 358Get this manual
Section 06 ELECTRICAL Subsection 06 (INSTRUMENTS AND ACCESSORIES)
LEDs are good: Check wiring condition Check AMP connectors Change MPEM LEDs are burned: Change indicator lightsUse the same procedure to test the LEDs on the LH displayLEDS LED #1 LED #2 LED #3 LED #4 LED #5 WIRES COLOR REDBROWN and BLACKPINK REDBROWN and BLUEPINK REDBROWN and GREENPINK REDBROWN and VIOLETPINK REDBROWN and YELLOWPINK
Now the speedometer is supplied with 12 voltsUnder normal conditions the speedometer should display the following: backlight slight movement of the speedometer needle numbers on the meter
V01G2AA
NORMAL DISPLAY
LEDs are good: Check wiring condition Check AMP connectors Change MPEM LEDs are burned: Change indicator lights
If any of the above condition is not met, then check the wiring, VSS (Vehicle Speed Sensor) and connector conditionsIf normal, change speedometer