2004 Bombardier Quest/Traxter Series Shop Manual, Page 343Get this manual
Section 06 ELECTRICAL Subsection 05 (IGNITION SYSTEM)
Traxter Series Check resistance with high-sensitivity ohmmeter1Disconnect the Deutsch 6-pin connector at engine2Install the 6-pin magneto harness adapter (PN 295 000 136)
3Press START button, note resultThe obtained value should be between 0.4 and 0.7 VacRepeat operation times4If the trigger coil is out of specification, replace itIf it tests good continue the other testsTraxter Series 1Disconnect magneto wiring harness connector2Install the 6-pin magneto harness adapter (PN 295 000 136)3Connect one of the multimeter leads to the WHITEYELLOW wire of the 6-pin magneto harness adapter4Connect the other multimeter lead to the BLACK YELLOW wire of the 6-pin magneto harness adapter5Remove the ignition fuse and press STARTSTOP button, note resultThe obtained value should be between 0.4 and 0.7 Vac6If the trigger coil is out of specification, replace itIf it tests good continue the other tests
F01B28A