2004 Bombardier Quest/Traxter Series Shop Manual, Page 294Get this manual
Section 05 FUEL SYSTEM Subsection 03 (CARBURETOR AND FUEL PUMP) Refer to following photos for proper float level gauge positioningNOTE: Refer to TECHNICAL DATA for proper levelNOTE: On the AUTOSHIFT model, the TPS sensor calibration is necessaryAdjust the idle speed in first, then, calibrate the TPS sensorRefer to ELECTRIC SHIFT SYSTEM
Installation
To install carburetor on engine, inverse removal procedure, as described: Inspect throttle and choke cable housing prior to installation Reinstall throttle and choke cables, at the same time adjust the throttle cable, then install the side coverRefer to CARBURETOR ADJUSTMENTS below in this section Reinstall carburetor on engineWhen reinstalling carburetor on engine, pay attention to the following: CAUTION: The rubber flanges must be checked for cracks andor damageAt assembly, the rubber flanges must be perfectly matched with the air box, carburetor and engine or severe engine damage will occurDo not use screwdriver or other tool to install the rubber flangesTraxter Series Only