2004 Bombardier Quest/Traxter Series Shop Manual, Page 266Get this manual
Section 04 ENGINE TRAXTER Subsection 10 (CRANKSHAFTBALANCER SHAFT)
CAMSHAFT
Removal
To remove camshaft no1, do the following procedurePlace the vehicle on jack stands and place the shifter on NEUTRAL positionRemove seat then remove batteryDisconnect BLACK (-) cable from battery, then RED (+) cable
WARNING
Always disconnect battery or starter cables exactly in the specified order, BLACK (-) cable firstIt is recommended to disconnect electrical connections prior to disconnecting fuel linesDrain engine oil and engine coolant by removing drain plugs
Remove or unplug: cylinder head, cylinder and hydraulic lifters (refer to CYLINDER AND HEAD) sub transmission position sensor NOTE: Do not unplug only, remove sensor completely shifting rod vehicle speed sensor (unplug only) rewind starter (refer to REWIND STARTER) clutch cover and clutch drum (refer to CLUTCH) bolt no6, lock washer no7 and washer no8 retaining cam shaft gear no9 with centrifugal weight no10