2004 Bombardier Quest/Traxter Series Shop Manual, Page 261Get this manual
Section 04 ENGINE TRAXTER Subsection 09 (CYLINDER AND CYLINDER HEAD)
With the micrometer set to the dimension, adjust cylinder bore gauge to the micrometer dimension and set the indicator to (zero)
V01C3KA
TYPICAL 1Measuring perpendicularly (90) to piston pin axis A16 mm (58 in)
The measured dimension should be as described in the previous tableIf not, replace pistonPISTON MEASUREMENT SERVICE LIMIT 88.9 mm (3.5 in)
F00B09A
1Use the micrometer to set the cylinder bore gauge 2Dial bore gauge
PistonCylinder Clearance
PISTONCYLINDER CLEARANCE NEW SERVICE LIMIT 0.016 to 0.044 mm (.0006 to .002 in) 0.090 mm (.004 in)