2004 Bombardier Quest/Traxter Series Shop Manual, Page 239Get this manual
Section 04 ENGINE TRAXTER Subsection 05 (COOLING SYSTEM)
Fan Removal
Remove rear fenderRefer to BODYRemove bolts no18 and fan supports no191 1
Outlet Deflector Installation
The installation is the reverse of the removal procedure
TEMPERATURE SENDER
Remove temperature sender no13, see below for procedurePut sender in water and heat waterUsing multimeter, check the resistance from temperature senderTemperature sender should close when water temperature reaches the following degreeWATER TEMPERATURE 90 to 95 (194 to 203 F)
V01G0AA
TYPICAL 1Remove bolts 2Fan supports
Change temperature sender if the resistance does not change when the water temperature is equal or over specification