2004 Bombardier Quest/Traxter Series Shop Manual, Page 201Get this manual
Section 03 ENGINE QUEST Subsection 11 (CVT)
Cam Check cam no31 for visible damage and wear limit with caliperWEAR ON CONTACT SURFACE SERVICE LIMIT 2.000 mm (.079 in)
Spring Measure spring free length and squarenessIf spring is out of specification, replace by newSPRING FREE LENGTH SERVICE LIMIT 180 mm (7.087 in)
CLUTCH SPRING SQUARENESS SERVICE LIMIT 3.8 mm (.150 in)
Assembly of Driven Pulley
For installation, reverse the removal procedurePay attention to following details Heat ball bearing area up to 100C (212F) before ball bearing installationNOTE: Place new ball bearing in freezer for 10 minutes before installationInstall ball bearing no28 with the writing on top and push only on the outer ring